Hobart 6460 Vegetable Peeler – 60 lb.

MOTOR: 3⁄4 H.P., Model 6430; 1 H.P. Model 6460. The
motor features manual reset overload protection, greasepacked ball bearings, and ventilation within the peeler
enclosure. Single phase is capacitor-start, induction run,
and three phase is polyphase, squirrel-cage, induction-run
type.
ELECTRICAL SPECIFICATIONS: 115/60/1, 200-230/60/1,
200-230/60/3 UL Listed. 220-240/50/1, 380-415/50/3 —
Not submitted for UL Listing.
SWITCH: Manual tumbler type, located on right side of
discharge chute as standard. Switch can be relocated to
other side of chute if desired.
TIMER – Models 6430T and 6460T: Synchronous 5-minute
timer, adjustable for any increments from 1⁄2 minute up to
5 minutes, with 15-second markings etched on a large
timer dial. This timer is furnished only in single phase
specifications as standard.
DRIVE: Multigrip, poly V-belt provides the direct speed
reduction between motor and peeling disc. Belt adjustment
may be accomplished from outside the machine. The stainless steel drive shaft is rigidly mounted on grease-packed
ball bearings. Advanced designed triple protection sealing
prevents entrance of water into shaft bearings.
PEELER UNIT: Cylindrical construction, heliarc-welded
stainless steel with removable NSF approved Lexan liner.
A one piece, reinforced plastic molded, lightweight, easily
removable, positive locking hopper cover is provided for
easy cleaning. Quick-opening removable aluminum hopper
door and positive, cam-type pressure lock. Discharge chute
is ball burnished cast aluminum. To facilitate installation,
the peeler unit can be positioned at 90° intervals, in relation
to the peel trap unit.
ABRASIVE DISC: An extremely lightweight fiberglass
reinforced plastic disc is 20 1⁄2 inches in diameter. The
silicon-carbide abrasive is permanently bonded to the disc,
assuring unequaled long service. Disc can be easily and
quickly removed for cleaning by removing the lightweight
hopper cover. Two angle mounted wipers provide positive
movement of waste into the outlet.
WORKING CAPACITY: Model 6430 peels 30-33 pounds
in one to three minutes. Model 6460 Peeler peels 50-60
pounds in similar time.
FINISH: Peeler and peel trap unit are glass-beaded
stainless steel. Plastic molded hopper cover is gray. Door
and handle, discharge chute, and legs are cast aluminum
and ball burnished for durability. Bottom of peeler unit is
cushioned in resilient rubber trim molding.
WATER INLET: The inlet is the air-gap type, mounted at the
rear of the peeler unit at sufficient height to meet plumbing
codes. The water from the inlet impinges on the curved surface of the hopper cover to form a fan pattern of water into
the unit. This design promotes interior self-cleaning and
forms a water curtain which prevents undesirable splash.